Axis Wakeboard Boat Forum :: View topic

OK so first off I'd wire the amps B+ to the common post on the switch (so your stereo isn't drawing down one battery while you use another). The other bonus is that the amps will be cut off from power when you turn the switch off.

Then take a 10awg duplex wire run either from your amps' distro blocks or from one of your amp's power block itself over to the helm to power the stereo accessories there. Remember to fuse that wire from the amps. I've had good luck in the past using a blue sea 5025 power/ground block. Make sure you don't hook up more accessories than the 10awg can handle (unlikely with EQ / BT). Connect the accessories to the fuse block with ring terminals. Make sure you get good crimps on them, and it never hurts to solder them.

Author:	r33pwrd [ Thu Aug 18, 2016 10:54 am ]
Post subject:	Stereo wiring question
So I have some noise from my stereo so I want to rewire the whole thing.. I have: -Exile ZLD -Factory deck (all I use it for is remote turn on for amps) -Exile BT -5 channel amp -2 channel amp I ordered all new RCA cables but I also want to rewire power and ground for the stuff on the drivers helm. I want to isolate them from everything else on the boat. Is it okay to run a power and ground from the battery to a terminal block under the dash and them hook up the head unit, ZLD and BT to it? Or do I need to run independent lines for each? I assume I want to grab power and ground from the same posts on the same battery that the amps are wired to? I have developed a bad whine and static sound when the ballast pumps are on.. Thank you Brad

Author:	shawndoggy [ Thu Aug 18, 2016 2:54 pm ]
Post subject:	Re: Stereo wiring question
how many batteries do you have and how are they hooked up (i.e. perko / blue sea add a battery / etc)? Where do the amps get their power (straight from battery or from perko common post or....)?

Author:	r33pwrd [ Thu Aug 18, 2016 4:05 pm ]
Post subject:	Re: Stereo wiring question
Factory dual battery setup and switch (not sure brand but I can look tonight). Currently the amps are wired directly to one of the batteries. Sent from my SAMSUNG-SM-G925A using Tapatalk

Author:	shawndoggy [ Thu Aug 18, 2016 4:30 pm ]
Post subject:	Re: Stereo wiring question
OK so first off I'd wire the amps B+ to the common post on the switch (so your stereo isn't drawing down one battery while you use another). The other bonus is that the amps will be cut off from power when you turn the switch off. Then take a 10awg duplex wire run either from your amps' distro blocks or from one of your amp's power block itself over to the helm to power the stereo accessories there. Remember to fuse that wire from the amps. I've had good luck in the past using a blue sea 5025 power/ground block. Make sure you don't hook up more accessories than the 10awg can handle (unlikely with EQ / BT). Connect the accessories to the fuse block with ring terminals. Make sure you get good crimps on them, and it never hurts to solder them.

Author:	dustinjean [ Thu Aug 18, 2016 5:14 pm ]
Post subject:	Re: Stereo wiring question
My ws420sw had a bad engine noise until I ran power and ground for the factory head unit and the 420sq straight to the amp distribution blocks, have you done that? Sent from my SM-G900V using Tapatalk

Axis Wakeboard Boat Forum http://www.axiswakeboardboats.com/

Stereo wiring question http://www.axiswakeboardboats.com/viewtopic.php?f=16&t=3917	Page 1 of 2

Author:	r33pwrd [ Thu Aug 18, 2016 5:24 pm ]
Post subject:	Re: Stereo wiring question
dustinjean wrote: My ws420sw had a bad engine noise until I ran power and ground for the factory head unit and the 420sq straight to the amp distribution blocks, have you done that? Sent from my SM-G900V using Tapatalk I belive I did but can't remember if I did for the bluetooth. Sent from my SAMSUNG-SM-G925A using Tapatalk

Author:	r33pwrd [ Thu Aug 18, 2016 5:25 pm ]
Post subject:	Re: Stereo wiring question
shawndoggy wrote: OK so first off I'd wire the amps B+ to the common post on the switch (so your stereo isn't drawing down one battery while you use another). The other bonus is that the amps will be cut off from power when you turn the switch off. Then take a 10awg duplex wire run either from your amps' distro blocks or from one of your amp's power block itself over to the helm to power the stereo accessories there. Remember to fuse that wire from the amps. I've had good luck in the past using a blue sea 5025 power/ground block. Make sure you don't hook up more accessories than the 10awg can handle (unlikely with EQ / BT). Connect the accessories to the fuse block with ring terminals. Make sure you get good crimps on them, and it never hurts to solder them. Great input I was thinking pretty much the same as what you are saying. I assume ground the amps directly to the B battery? And all grounds to the same battery? Sent from my SAMSUNG-SM-G925A using Tapatalk

Author:	r33pwrd [ Thu Aug 18, 2016 5:41 pm ]
Post subject:	Re: Stereo wiring question
Okay just to clarify you say b+ common so you mean on the b battery side or on the common post so it's drawing off both batteries? Sent from my SAMSUNG-SM-G925A using Tapatalk

Author:	shawndoggy [ Thu Aug 18, 2016 5:44 pm ]
Post subject:	Re: Stereo wiring question
r33pwrd wrote: Great input I was thinking pretty much the same as what you are saying. I assume ground the amps directly to the B battery? And all grounds to the same battery? Just pick a battery, one or the other. Doesn't matter which because the two batteries are also grounded to one another. I would have one fat trunk line (0awg) to the battery, which goes to your ground distro block, where your amps are grounded. You'd also ground all of your stereo accessories there too (HU/EQ/BT) via the ground/fuse block discussed above.

Author:	r33pwrd [ Thu Aug 18, 2016 6:10 pm ]
Post subject:	Re: Stereo wiring question
Cool thanks Sent from my SAMSUNG-SM-G925A using Tapatalk

Page 1 of 2	All times are UTC - 6 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/