Axis Wakeboard Boat Forum
http://www.axiswakeboardboats.com/

Bad pop on rev10 at medium volume
http://www.axiswakeboardboats.com/viewtopic.php?f=15&t=3152
Page 1 of 1

Author:  arkryder [ Sun Jul 05, 2015 11:19 am ]
Post subject:  Bad pop on rev10 at medium volume

Newly installed rev10 have a bad pop when speakers are at medium volume. Any info would be appreciated. Got a pair of rev10 and replaced my stock Titan speakers also got a wetsounds sd2 amplifier had four different speaker wires going to old speakers and instead of not using two wires I just ohmed everything out and ran each speaker from two sets of speaker wires(if that makes sense so far). The amp I installed is supposed to be tuned for rev10 already. On the amplifier side I have speakers bridged. Don't know if this could be problem but don't know today I am going to try to run both speakers off channel one only and see if this helps. Sucks spending all this money and speakers popping.

Author:  arkryder [ Tue Jul 07, 2015 6:40 pm ]
Post subject:  Re: Bad pop on rev10 at medium volume

Just so everyone knows I found my popping noise it was my cabin speakers turned my gain all the way down on them and cleared it out.

Author:  AJWest [ Tue Jul 07, 2015 6:43 pm ]
Post subject:  Re: Bad pop on rev10 at medium volume

Improperly set gains can cause havoc in a stereo

Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/