Axis Wakeboard Boat Forum http://www.axiswakeboardboats.com/ |
|
2016 A24 actuator http://www.axiswakeboardboats.com/viewtopic.php?f=14&t=4906 |
Page 1 of 1 |
Author: | twowakes [ Sun May 03, 2020 6:18 pm ] |
Post subject: | 2016 A24 actuator |
The actuator on the port side surf gate has went out for the second time in the last 2 years. They replaced it with the updated actuator the last time. Unfortunately i just crossed the 500 hour mark so it will not be covered under warranty. Does anyone have a lead on where we can source the actuators without paying dealership prices? TIA |
Author: | WayneTuttle [ Sun May 10, 2020 11:23 am ] |
Post subject: | Re: 2016 A24 actuator |
I just picked up 2 on Amazon. One went bad, and I bought a replacement and a spare. Paid $227 each. |
Author: | gtoddh [ Fri May 29, 2020 7:07 pm ] |
Post subject: | Re: 2016 A24 actuator |
twowakes wrote: The actuator on the port side surf gate has went out for the second time in the last 2 years. They replaced it with the updated actuator the last time. Unfortunately i just crossed the 500 hour mark so it will not be covered under warranty. Does anyone have a lead on where we can source the actuators without paying dealership prices? TIA There's an hour limit on the warranty? |
Author: | A22owner [ Mon Jun 08, 2020 6:31 am ] |
Post subject: | Re: 2016 A24 actuator |
gtoddh wrote: twowakes wrote: The actuator on the port side surf gate has went out for the second time in the last 2 years. They replaced it with the updated actuator the last time. Unfortunately i just crossed the 500 hour mark so it will not be covered under warranty. Does anyone have a lead on where we can source the actuators without paying dealership prices? TIA There's an hour limit on the warranty? Yes, you should always read the policy anytime you make a major purchase. |
Author: | lynnjoshua [ Sun Jun 21, 2020 7:44 pm ] |
Post subject: | Re: 2016 A24 actuator |
Quick question I had a actuator on my 14 A24 fail so I replaced with recommended replacement. All the measurements were correct and functions fine when testing out of water. But when I enable it on the water and get to speed I get a fault that it’s not extending. I shut boat off recalibrate and it retracts fine. I have cycled it a few times and it’s still doing the same thing? Any tips would greatly be appreciated!! Sent from my iPhone using Tapatalk |
Page 1 of 1 | All times are UTC - 6 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |